ZANKER KIT6460XXK Manual de usuario Pagina 26

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 60
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 25
Problem Possible cause Remedy
You can hear a constant beep
noise.
The electrical connection is incor-
rect.
Disconnect the hob from the electri-
cal supply. Ask a qualified electri-
cian to check the installation.
If you cannot find a solution...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service Centre.
Give the data from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.
Make sure, you operated the hob correctly. If not the
servicing by a service technician or dealer will not be
free of charge, also during the warranty period. The
instructions about the Service Centre and conditions of
guarantee are in the guarantee booklet.
Installation
Warning! Refer to Safety chapters.
Before the installation
Before you install the hob, write down the information
bellow from the rating plate. The rating plate is on the
bottom of the hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble the hob
into correct built-in units and work surfaces that align to
the standards.
Connection cable
The hob is supplied with a connection cable.
To replace the damaged mains cable, use the cable
type: H05V2V2-F which withstands a temperature of
90°C or higher. Speak to your local Service Centre.
Assembly
min.
50mm
min.
500mm
R 5mm
min.
55mm
560
+1
mm
490
+1
mm
26
Vista de pagina 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 59 60

Comentarios a estos manuales

Sin comentarios