ZANKER KEV6442FBB Manual de usuario Pagina 23

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 56
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 22
Problem Possible cause Remedy
You touched 2 or more sensor fields
at the same time.
Touch only one sensor field.
There is water or fat stains on the
control panel.
Clean the control panel.
An acoustic signal sounds and the
hob deactivates.
An acoustic signal sounds when the
hob is deactivated.
You put something on one or more
sensor fields.
Remove the object from the sensor
fields.
The hob deactivates. You put something on the sensor
field .
Remove the object from the sensor
field.
Residual heat indicator does not
come on.
The zone is not hot because it op-
erated only for a short time.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
Automatic Heat Up function does
not operate.
The zone is hot. Let the zone become sufficiently
cool.
The highest heat setting is set. The highest heat setting has the
same power as the function.
You decreased the heat setting to
.
Start from and only increase the
heat setting.
You cannot activate the outer ring. Activate the inner ring first.
There is a dark area on the
multiple zone.
It is normal that there is a dark area
on the multiple zone.
The sensor fields become hot. The cookware is too large or you
put it too near to the controls.
Put large cookware on the rear
zones if possible.
comes on.
Automatic Switch Off operates. Deactivate the hob and activate it
again.
comes on.
The Child Safety Device or the Lock
function operates.
Refer to "Daily use" chapter.
and a number come on.
There is an error in the hob. Disconnect the hob from the electri-
cal supply for some time. Discon-
nect the fuse from the electrical sys-
tem of the house. Connect it again.
If comes on again, speak to an
Authorised Service Centre.
E6 comes on. The second phase of the power
supply is missing.
Check if the hob is correctly connec-
ted to the electrical supply. Remove
the fuse, wait one minute, and insert
the fuse again.
23
Vista de pagina 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 55 56

Comentarios a estos manuales

Sin comentarios