ZANKER ZKF680ITXB Manual de usuario descargar pdf (Pagina 24)

51.003). If you use flexible metallic pipes, be careful

they do not come in touch with mobile parts or they are

not squeezed. Also be careful when the hob is put

together with an oven.

Make sure that the gas supply pressure

of the appliance obeys the

recommended values. The adjustable

connection is fixed to the comprehensive

ramp by means of a threaded nut R 1/2".

All the components shown in the figure

have already been assembled in the

factory. The appliance, before leaving

the factory, has been tested in order to

give you the best results.

A B C

A. End of shaft with nut

B. Washer supplied with the appliance

C. Elbow supplied with the appliance

Liquid gas

Use the rubber pipe holder for liquid gas. Always

engage the gasket. Then continue with the gas

connection.

The flexible pipe is prepared for apply when:

• it can not get hot more than room temperature,

higher than 30°C;

• it is no longer than 1500 mm;

• it shows no throttles;

• it is not subject to traction or torsion;

• it does not get in touch with cutting edges or

corners;

• it can be easily examined in order to make sure its

condition.

The control of preservation of the flexible pipe consists

in checking that:

• it does not show cracks, cuts, marks of burnings on

the two ends and on its full length;

• the material is not hardened, but shows its correct

elasticity;

• the fastening clamps are not rusted;

• expired term is not due.

If one or more defects are visible, do not repair the pipe,

but replace it.

Warning! When installation is complete,

make sure that the seal of each pipe

fitting is correct. Use a soapy solution,

not a flame!

Injectors replacement (only for Belgium)

1. Remove the pan supports.

2. Remove the caps and crowns of the burner.

3. With a socket spanner 7 remove the injectors and

replace them with the ones which are necessary for

the type of gas you use (see table in "Technical

Information" chapter).

4. Assemble the parts, follow the same procedure

backwards.

5. Replace the rating plate (it is near the gas supply

pipe) with the one for the new type of gas supply.

You can find this plate in the package supplied with

the appliance.

If the supply gas pressure is changeable or different

from the necessary pressure, you must fit an applicable

pressure adjuster on the gas supply pipe.

Adjustment of minimum level (only for Belgium)

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the bypass screw

position (A).

5. If you change:

• from natural gas G20/G25 20/25 mbar to liquid

gas, fully tighten the bypass screw in.

• from liquid gas to natural gas G20/G25 20/25

mbar, undo the bypass screw approximately

1/4 of a turn (1/2 of a turn for Triple Crown

burner).

Warning! Make sure the flame does not

go out when you quickly turn the knob

from the maximum position to the

minimum position.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Comentarios a estos manuales

Sin comentarios

ZANKER ZKF680ITXB Manual de usuario Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Placas ZANKER ZKF680ITXB