ZANKER ZKM6530DX Manual de usuario Pagina 10

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 12
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 9
cleaning agent for glass ceramic or stainless
steel.
2. Clean the appliance with a moist cloth and some
detergent.
3.
At the end rub the appliance dry with a clean
cloth.
What to do if...
Problem Possible cause and remedy
You cannot start the appliance or
operate it.
You touched 2 or more sensor fields at the same time. Only touch
one sensor field.
There is water or fat stains on the control panel. Clean the control
panel.
The child safety device or key lock operates. See the chapter Oper-
ating the appliance.
Start the appliance again and set the heat setting in 10 seconds.
The cooking zone reduces the heat
setting to
You covered one or more sensor fields or there is water or fat stains
on the control panel. Uncover the sensor fields. Clean the control panel.
A sound operates when the appli-
ance is off.
You covered one or more sensor fields. Uncover the sensor fields.
The residual heat indicator does
not come on.
The cooking zone is not hot because it operated only for a short time.
If the cooking zone is supposed to be hot, speak to the After Sales Serv-
ice.
Heat setting alternates The Power management is active. See the section Power management.
A sound operates and appliance
starts and stops again. After 5 sec-
onds one more sound operates.
You covered . Uncover the sensor field.
comes on
The automatic switch-off operates. Stop the appliance and start it
again.
Overheating protection for the cooking zone operates. Switch off the
cooking zone. Switch on the cooking zone again.
comes on
No cookware on the cooking zone. Put cookware on the cooking zone.
Not correct cookware. Use the correct cookware.
The diameter of the bottom of the cookware is too small for the cook-
ing zone. Move cookware to a smaller cooking zone.
and number come on.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some time. Dis-
connect the fuse from the electrical system of the house. Connect
again. If
comes on again, speak to the After Sales Service.
10
Vista de pagina 9
1 2 ... 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios